Hobie Forums http://www.hobie.com/forums/ |
|
Busted Seat http://www.hobie.com/forums/viewtopic.php?f=11&t=4359 |
Page 1 of 1 |
Author: | yakandjak [ Fri Jul 28, 2006 7:34 pm ] |
Post subject: | Busted Seat |
Hey gang. Just got my new Outfitter. Everyone here was very helpful in the selection. Thanks much. Second day out I put my seat a little more upright sat back and...SNAP! The plastic eyelet where the seat clasp connects broke right off (the plug is still in just the top part is gone). I weigh about 220. Did I exceed the breaking point of this little guy or is it more likely I just got one that was weaker than average? Any suggestions on how to go about fixing this? Perhaps replacing it with a steel dohickey? Thanks much for your help! Burt |
Author: | mmiller [ Sat Jul 29, 2006 10:32 am ] |
Post subject: | Eyelet |
The eyelet is a screw-in fitting and can be replaced. We have not seen a lot of failures, but have failed some during installation, so we have gone to a non-fiber-filled nylon for more overall breaking strength. The nylon may distort a bit more, but should not shear like the glass-filled version. Not sure the dates of the change or even if they are in current boat production yet. In any case... very sorry for the problem. Contact a dealer for the replacement parts under warranty. |
Author: | yakandjak [ Sat Jul 29, 2006 12:08 pm ] |
Post subject: | |
No worries Matt. I was able to hook into the eyelet to the left of the storage compartment on the deck so the day was not a total loss. I'll give my dealer a hollar. Thanks much. Burt |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |