Hobie Forums http://www.hobie.com/forums/ |
|
Small Hole In An Important Spot http://www.hobie.com/forums/viewtopic.php?f=11&t=44180 |
Page 1 of 1 |
Author: | jjjankovsky [ Mon Jul 30, 2012 7:28 am ] |
Post subject: | Small Hole In An Important Spot |
After beaching a Mirage Outback and discovering the hull was awash with water inside, we discovered a small hole under the front mounting area of the machine. My question concerns how to patch effectively in this area which seems to be a wear/impact area, and how to avoid too much build-up of patch material that would prevent the metal from seating under the turn-knob. Ideas? |
Author: | mmiller [ Tue Jul 31, 2012 4:48 pm ] |
Post subject: | Re: Small Hole In An Important Spot |
Plastic welding. You can fill and then file or sand down a repair. Knobs? How old is the kayak? It may be eligible for warranty coverage. Contact a Hobie Dealer. |
Author: | jjjankovsky [ Tue Jul 31, 2012 7:21 pm ] |
Post subject: | Re: Small Hole In An Important Spot |
the hull is from 2005 and i'm in mexico, without access to repair kits... can i carve off some of the hull from one of the extra plastic (if i can find some), then use it for a weld with perhaps a bit of screen (metal/plastic) added?...there must be some exra plastic on the edges of something there...? |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |