Hobie Cat Forums

It is currently Wed Aug 20, 2014 4:08 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 

Been frustrated installing bushings on Wheeleez cart for Outback?
yes 100%  100%  [ 1 ]
no 0%  0%  [ 0 ]
Total votes : 1
Author Message
PostPosted: Sun Dec 02, 2012 7:33 am 
Offline
Site Rank - Deck Hand

Joined: Tue Nov 27, 2012 8:50 am
Posts: 1
[i]Just purchased an 2013 Outback & Wheeleez foam wheel cart. The wheel cart came with bushings to place on the shafts of wheel cart & snug to scuppers for additional support. However, the bushings ARE IMPOSSIBLE[/b] to install!!

Calls to Hobie customer service & seller of the Outback, all said there is no known problem. Finally a Hobie technician said the wheel cart is not manufactured by Hobie & bushings are intended for much heavier Hobies & NOT for the Outback!! Bottom line: accompanying instructions do not say this!! but it's safe to use cart without the bushings. Tried installing them on a 2012 Outback tandem, with same results, they don't work.

Have since heard cutting a tennis ball in half, placing each half on each shaft of the cart will somewhat buffer the inserting of the cart into the scuppers.]


Top
 Profile  
 
PostPosted: Wed Dec 12, 2012 7:17 pm 
Offline
Site Rank - Captain

Joined: Thu Apr 19, 2012 6:38 pm
Posts: 37
I have a 2011 Hobie Outback and the wheeled cart you describe. I used the cart bushing but cover them with two tennis balls with X cuts in them that allow the balls to cover the bushing. It should be noted that the bushing are set a little lower to allow for this without actually rubbing up again the kayak and deforming the hull. The padded cross support shaft also can cause the hull to deform, if the kayak is left on it too long. The problem is you are asking a curved hull to be supported by a straight padded bar resulting in too much stress in a small area. My solution to this was to go the Autozone store and get some auto seat belt webbing. I cut the belt to a length, that when two one inch holes are cut into the belt at either end and then you slide the belt over the upright posts of the cart, creating a loop cradle effect that matches the curvature of the hull. The result is no hull deformity when left on the cart. Hope this gives you some ideas.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group