Hobie Cat Forums

It is currently Fri Aug 01, 2014 5:38 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sun Sep 17, 2006 5:03 pm 
Offline
Site Rank - Deck Hand

Joined: Wed Jul 26, 2006 2:46 pm
Posts: 4
Location: Redding, CA
:?: :?: Just took delivery on 07 Adventure and was doing some rigging and loose plastic clean up. Noticed a pin hole at the rear of the dagger board slot right where it joins the the bottom. Haven't had the hull in the water yet but am sure it will leak. Any suggestions patching or should I just take it back to the dealer? I have already mounted a flag on the stern deck and a eye in front of the peddals to put a teather on. Thanks for the input. I am going to post this on the Hobie formum on KFS too. Mike

_________________
I haven't had this much fun since the pigs ate my baby sister.


Top
 Profile  
 
 Post subject: Pin hole?
PostPosted: Mon Sep 18, 2006 8:56 am 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 8918
Location: Oceanside, California
Pin hole? Could be a little bubble, but certainly, if it is a leak point, take it back to the dealer for review. This may be easily corrected or replaced if needed.

_________________
Matt Miller
Director of Parts and Accessory Sales
Hobie Cat USA


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group