We just purchased a 20013 Oasis this past weekend and have been out on it twice. So far we are loving the kayak, I will put up a separate review post later. I was wiping down the bottom of the kayak hull last night after we went out on it and I noticed what appears to be a bubble in the hull that was cut into at the mirage drive location. It looks like Hobie smooths out this area either by hand or with a machine. The hole in the hull doesn't go all the way through but since it is at the marine drive area, which appears to get a lot of stress from what I have been reading, should I be concerned?
We live 40 miles from the dealer and they delivered the kayak to us (for a price) since we have no way to transport it so we can't just load it up and take it to them to show them for their opinion.