Hobie Forums http://www.hobie.com/forums/ |
|
Island Gudgeon FAQ http://www.hobie.com/forums/viewtopic.php?f=114&t=49754 |
Page 1 of 1 |
Author: | mmiller [ Thu Nov 07, 2013 9:50 am ] |
Post subject: | Island Gudgeon FAQ |
I compiled a history as best as possible. This shows possible configurations starting from early boats to current. - Original Twist and Stow rudders. 2 hole gudgeon with 2x 8030214 SCREW 1/4-20 x 1" BTN HD (may have had phillips heads now has allen) - Retrofitted rudders - same fasteners - Changed insert to add 3rd leg (visible 3rd hole) to add strength to transom. More plastic and 3rd leg creates more resistance to pulling out or pushing in. - Updated lower screw to PH17-4 higher strength stainless. Production fasteners are not available in PH17-4, so we constructed of a stud and seized hex nut for a head (slotted end on stud) Upper 8030214 SCREW 1/4-20 x 1" BTN HD / Lower 8030346 SCREW W/NUT ISLAND GUDGEON STUD 1/4-20 x 1" PH17-4 W/ NUT SEIZED - Decision was made to replace the PH17-4 assembled part and go to a larger diameter (and commercially available) 5/16-24 screw and use both upper holes with 1/4-20s. Late March 2012 started 3 hole gudgeons with 1x 8030355 SCREW 5/16-24 x 3/4 BTN HD SCK Lower and 2x 8030214 SCREW 1/4-20 x 1" BTN HD Uppers. - AI hulls started coming with the same 3 hole gudgeon and fasteners in late 2013. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |