Hobie Cat Forums

It is currently Tue Sep 30, 2014 1:21 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sat Aug 13, 2005 5:59 am 
Offline
Site Rank - Deck Hand

Joined: Sat Aug 13, 2005 5:51 am
Posts: 1
I TRIED TO FOLLOW MATT'S ADVICE ON USING A 5 FT 6 IN PIECE OF SHOCK CORD FOR A "JIBSHEET TANGLE PREVENTER AND THE PIECE WAS ABOUT 2 FOOT SHORT. IS THERE A SPECIAL BRAND OF CORD. I USES A PIECE FROM WEST MARINE AND IT WOULD NOT REACH FROM STRICKER TO SPREADERS AND BACK DOWN


Top
 Profile  
 
 Post subject:
PostPosted: Sat Aug 13, 2005 9:26 am 
Offline
Site Rank - Captain

Joined: Mon Aug 09, 2004 9:35 pm
Posts: 82
Location: Northern Texas
Whoa there big guy! :shock: The shock cord should go from striker on lets say port hull, up to where the diamond wires attach at the turnbuckles on the mast (not the spreaders). Run the bungee from the aft side of the mast around the front of the mast and back towards the aft through the opposite turnbuckle and finally down to the striker bar on the starboard hull. The bungee should only go to the diamond wire turnbuckles, not the spreaders. Hope this helps. :D


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: Exabot [Bot] and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group