Hobie Forums http://www.hobie.com/forums/ |
|
What is up with my rudder castings? http://www.hobie.com/forums/viewtopic.php?f=13&t=42926 |
Page 1 of 1 |
Author: | flaco [ Fri May 25, 2012 11:56 am ] |
Post subject: | What is up with my rudder castings? |
A few weeks ago while breaking my boat down after a sail, I noticed my rudder pins were really hard to get out. One was bent for sure, so I replaced them and noticed that it was actually one of the lower castings, twisted about 1/4" out of alignment. Damn !! Got a used one. Last weekend, on a reach in +/- 15 of wind, the lee rudder appeared to pop up. Nope, lower casting snapped clean in half ! Back on the beach, noticed BOTH pins were bent again (SS pins mind you, not the stock aluminum). After my first casting, I spent some time adjusting the rudders and cams. The helm was really nice, barely noticible weather helm, and rudders locked down nicely. What the hell is going on ?? I understand that castings can and do break, but my last set of pins lasted years. |
Author: | Harry Murphey [ Fri May 25, 2012 3:19 pm ] |
Post subject: | Re: What is up with my rudder castings? |
Solid SS ... or ... hollow SS ??? I have bent solid SS rudder pins before ... so it does happen .... hollow are stiffer and I haven't bent one ... yet .... |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |