Hobie Forums
http://www.hobie.com/forums/

Rudder Casting Bushing Part#8062001.....
http://www.hobie.com/forums/viewtopic.php?f=13&t=43638
Page 1 of 1

Author:  BrianCT [ Tue Jul 03, 2012 10:23 am ]
Post subject:  Rudder Casting Bushing Part#8062001.....

I broke two of my old rudder casting bushings a couple of weeks ago and my boat has been "squirrely" ever since. I'm going to be fitting new ones this evening. My question is - Do you guys epoxy the bushings in place or just tap them in and call it good? Thank you.

P.S. The castings in question are the old-style H18 castings. I see "Rudder casting bushings Part#8062001 in the parts catalogue but also see NYLINER #8061011 in the assembly manual. Which of these do I need? I just want to tighten up the pin.

Author:  presto13031 [ Tue Jul 03, 2012 12:28 pm ]
Post subject:  Re: Rudder Casting Bushing Part#8062001.....

I used the bushings and couldn't be happier. I used a dab of silicone RTV to hold them in place.

Author:  BrianCT [ Tue Jul 03, 2012 12:32 pm ]
Post subject:  Re: Rudder Casting Bushing Part#8062001.....

Thanks Jeff, I just picked a set up from my dealer. Have a great Fourth!

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/