Hobie Forums
http://www.hobie.com/forums/

How do I attach the jib line end to furler spool?
http://www.hobie.com/forums/viewtopic.php?f=13&t=45276
Page 1 of 1

Author:  jeb [ Mon Oct 08, 2012 5:44 am ]
Post subject:  How do I attach the jib line end to furler spool?

What is the correct way to attach jib line end to the furler spool?

Author:  srm [ Mon Oct 08, 2012 9:08 am ]
Post subject:  Re: How do I attach the jib line end to furler spool?

There is a small hole on the bottom of the spool. Pass the line into the opening at the back of the furler housing and down through the hole in the bottom of the spool. Then tie either an overhand or a figure eight knot so the line can't be pulled through the spool. Then wind up the spool.

sm

Author:  Harry Murphey [ Tue Oct 09, 2012 11:59 am ]
Post subject:  Re: How do I attach the jib line end to furler spool?

Just remember to wind it in the correct direction ....

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/