Hobie Forums http://www.hobie.com/forums/ |
|
Gelcoat repairs in the daggerboard wells http://www.hobie.com/forums/viewtopic.php?f=13&t=47100 |
Page 1 of 1 |
Author: | SNovak [ Fri Apr 05, 2013 12:49 pm ] |
Post subject: | Gelcoat repairs in the daggerboard wells |
Does anyone have any tips and tricks to share for repairing gel-coat chips and dings in the daggerboard wells, or is it all just a lot of patience? I've been trying to go after a few on my boat, and its a royal pain... |
Author: | aaron-hobie [ Tue Apr 09, 2013 7:04 am ] |
Post subject: | Re: Gelcoat repairs in the daggerboard wells |
I know its not well specific, but there was an article in the may-june 2009 issue of the hobie hotline on gelcoat chips and dings. http://www.w1dm.com/projects/hotline/09 ... OTLINE.pdf maybe that will be helpful... |
Author: | divimon2000 [ Tue Apr 16, 2013 1:04 pm ] |
Post subject: | Re: Gelcoat repairs in the daggerboard wells |
Your gonna need to get sandpaper down in there with a stick or better yet a dremel with a long reach to grind out the area and bevel. Use a custom tool to get the glass or mixed resin (with glass beads or something) onto the area and hold it. A bit of mold release on the tool will help. Maybe the tool is shaped like your pocket "V". of course the more you make a mess, the more you have to grind out later Patience is your friend. |
Author: | zstevens [ Sun May 19, 2013 8:25 pm ] |
Post subject: | Re: Gelcoat repairs in the daggerboard wells |
I used dowel rods wrapped & taped sand paper on em! |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |