Hobie Cat Forums

It is currently Sun Aug 31, 2014 2:17 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: Aft corner castings
PostPosted: Mon Feb 14, 2005 3:33 pm 
Offline
Site Rank - Captain

Joined: Mon Oct 11, 2004 12:24 am
Posts: 143
Location: Edmond Oklahoma
On my 1973 H-16. There is a 7/32 diameter hole on the starboard and port aft rear castings. Both are on the out board side of the casting what are/were they used for?

Todd


Top
 Profile  
 
 Post subject: Hole?
PostPosted: Mon Feb 14, 2005 4:59 pm 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 8978
Location: Oceanside, California
Hole? They counter sunk too? Sounds like the tramp lacing start point.

Rear lacings start at the rear / outboard corner casting. Pass the 1/4 inch line through that hole and tie a stop knot (knot is inboard, the line exits the hole towards the outboard). The line then runs forward and around the casting to the first tramp grommet.

_________________
Matt Miller
Director of Parts and Accessory Sales
Hobie Cat USA


Top
 Profile  
 
 Post subject:
PostPosted: Mon Feb 14, 2005 10:07 pm 
Offline
Site Rank - Captain

Joined: Mon Oct 11, 2004 12:24 am
Posts: 143
Location: Edmond Oklahoma
Thanks Matt You are right. I looked it up on the support page, Assyembly manual. This has to be it. The pic on adobe is hard to see. Any one gota pic so I can see how there strung. Mine is not threaded through the castings. It supports everyone fine. I'm sure thier rigged this way for a reason.

Thanks

Todd


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group