Hobie Forums http://www.hobie.com/forums/ |
|
Aft corner castings http://www.hobie.com/forums/viewtopic.php?f=14&t=1532 |
Page 1 of 1 |
Author: | tchristian [ Mon Feb 14, 2005 3:33 pm ] |
Post subject: | Aft corner castings |
On my 1973 H-16. There is a 7/32 diameter hole on the starboard and port aft rear castings. Both are on the out board side of the casting what are/were they used for? Todd |
Author: | mmiller [ Mon Feb 14, 2005 4:59 pm ] |
Post subject: | Hole? |
Hole? They counter sunk too? Sounds like the tramp lacing start point. Rear lacings start at the rear / outboard corner casting. Pass the 1/4 inch line through that hole and tie a stop knot (knot is inboard, the line exits the hole towards the outboard). The line then runs forward and around the casting to the first tramp grommet. |
Author: | tchristian [ Mon Feb 14, 2005 10:07 pm ] |
Post subject: | |
Thanks Matt You are right. I looked it up on the support page, Assyembly manual. This has to be it. The pic on adobe is hard to see. Any one gota pic so I can see how there strung. Mine is not threaded through the castings. It supports everyone fine. I'm sure thier rigged this way for a reason. Thanks Todd |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |