On the mast installing mast tang and cleats.
ASSEMBLY ORDER:Using the tang as the example is the assembly order?:
A Mast, casing , tang, rivet?
or
B Mast, tang, casing, rivet ( am assuming this is correct)
DRILL BIT SIZE:Also if I drill out the mast with a 13/64 (.203") drill bit, the bare rivet fits well, but the casing and rivet won't fit due to the casing being a bit larger than the rivet.
If I drill the mast with a 7/32 (.218") drill bit, the casing will fit in but this bit is too large to pass through the tang that I am using as a template to drill as I install it.
.209 seems to be just right
What is the correct size to use with the casing?. Just want to be sure
thanks