Hobie Forums http://www.hobie.com/forums/ |
|
Are the aluminum frame tubes sealed? http://www.hobie.com/forums/viewtopic.php?f=14&t=43394 |
Page 1 of 1 |
Author: | bluesman [ Wed Jun 20, 2012 6:15 am ] |
Post subject: | Are the aluminum frame tubes sealed? |
I am wondering if the 4 aluminum extrusions that make up the square frame the tramp attaches to are sealed. I am assuming they are not. I have some holes in my front tube (above the dolphin striker) where rivets used to hold the original jib blocks and I am wonderinging if water gets in there if it will just drain right out?? I am lake sailing. |
Author: | 56kz2slow [ Wed Jun 20, 2012 6:16 am ] |
Post subject: | Re: Are the aluminum frame tubes sealed? |
No they are not sealed and do not need to be. |
Author: | bluesman [ Wed Jun 20, 2012 7:04 am ] |
Post subject: | Re: Are the aluminum frame tubes sealed? |
Thanks |
Author: | PurdueZach [ Wed Jun 20, 2012 11:05 am ] |
Post subject: | Re: Are the aluminum frame tubes sealed? |
No they are not and the connections to the corner castings are loose enough that I would think water could get out. I wouldn't worry about it unless you hear a ton of water sloshing around inside. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |