Hobie Cat Forums

It is currently Tue Oct 21, 2014 11:00 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Thu Aug 08, 2013 7:05 am 
Offline
Site Rank - Admiral

Joined: Sat Jul 23, 2005 10:04 am
Posts: 156
Location: Bowie, MD
One of my tiller arms is bent and I am trying to replace it. I have the rivets out but still can't get the arm out of the casting.

Any suggestions?


Top
 Profile  
 
PostPosted: Thu Aug 08, 2013 7:30 am 
Offline
Site Rank - Admiral

Joined: Sat Jul 23, 2005 10:04 am
Posts: 156
Location: Bowie, MD
Never mind, I got it.

Rested upper casting on a vise with tiller arm between jaws but not tightened down. Cut a piece of wooden dowel about the same diameter as the tiller tube, put that on the back side of the tube and gave it a few good whacks. Popped right out!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group