| Hobie Forums http://www.hobie.com/forums/ |
|
| Question on re-gel coating a 16 http://www.hobie.com/forums/viewtopic.php?f=14&t=49581 |
Page 1 of 1 |
| Author: | CapeCat [ Mon Oct 14, 2013 8:24 am ] |
| Post subject: | Question on re-gel coating a 16 |
Hi- I am planning to re-gel coat my hulls this weekend (weather permitting) and wanted to see if I could get advice on a couple issues: 1.) I have scraped off the silicon caulking/seal that is on the seam of the deck-hull and wanted to know if I should gel coat the seam when I spray the hulls? Is there a reason it was sealed with silicon or just because they were joined after coming out of the mold? 2.) I plan to spray new gel-coat on the decks and wanted to see if it's best to simply sand down the original non-skid texture and then tape off and spray with gel-coat mixed with awlgrip non-skid particles? I appreciate any thoughts. Thanks |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|