Hobie Forums http://www.hobie.com/forums/ |
|
Mounting new swivel baseplates http://www.hobie.com/forums/viewtopic.php?f=14&t=766 |
Page 1 of 1 |
Author: | bcochran [ Sun May 02, 2004 7:41 pm ] |
Post subject: | Mounting new swivel baseplates |
Hi All, Origninally posted this over in the repair forum..thought I'd try here too. I'm helping a friend repair his Hobie 16, and I have a question about mounting the baseplate / pad for the swiveling mainsheet cam cleat. I didn't have access to a pnematic rivet tool, so I used a hand rivet tool with a 3/16 aluminum rivet. It seemed to work just fine, the plate is mounted and seems sturdy. My question is this...are we going to have a probelm using the aluminum rivet vs a stainless steel one? I'm more concerned with structural integrity...I don't mind replacing the aluminum rivet every season or so due to corrosion...I just don't want it to snap in a day or so when I get it on the water... I'd appreciate your thoughts. Sincerely, Brian Cochran |
Author: | sunjammers [ Mon May 03, 2004 12:02 pm ] |
Post subject: | |
I'm not sure how strong the Aluminum rivets are going to be, You can use screws instead of rivets if these do not hold up for you. Thanks, Brad Stephens www.sunjammers.com Hobie Division 15 Chairman Authorized Hobie/Vanguard/Hunter Dealer [email protected] 850-235-2281 Panama City Beach, FL |
Author: | bcochran [ Tue May 04, 2004 2:08 pm ] |
Post subject: | |
Thanks for your reply... I dunno either...it FEELS like a solid mount now, but I guess time will tell. I can eventually use a SS rivet, but that will take me some time to get the rivet and get the boat to a place where they can drive it. I'll let you know how it turns out. Again, thanks for your response. Brian |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |