Hobie Forums http://www.hobie.com/forums/ |
|
H17 rudders holes http://www.hobie.com/forums/viewtopic.php?f=15&t=1549 |
Page 1 of 1 |
Author: | jtlapp [ Thu Feb 17, 2005 11:20 am ] |
Post subject: | H17 rudders holes |
I purchased a couple of used rudders (excellent condition) which were used on a H16. I can see where the H17 holes should be but want to be as percise a possible. Is there a template I can use do ensure the holes are exactly where they should be? What size should the holes be? Thanks, Joe |
Author: | tchristian [ Thu Feb 17, 2005 11:31 am ] |
Post subject: | |
Go to the top of this screen click on support. Go to sailboats click look for rudders there you have it I would sugest you read in open fourm the thread on rudders. Its agood idea if you know of anyone with a good template on there boat to use them just a thought good luck Todd |
Author: | jtlapp [ Mon Feb 21, 2005 11:30 am ] |
Post subject: | rudder template |
Todd, Thank you for the information. I downloaded both versions of the template but the deminsions don't match. The length should be 9 3/8" and width 6 3/8" but the printed version is not even 9" wide. I printed both in portrait and landscape with no change. How do you get the correct size template? Joe |
Author: | mmiller [ Mon Feb 21, 2005 11:37 am ] |
Post subject: | Template size |
Template size... The size it prints will depend on your system. The scale is there on the template so you can reduce or enlarge to get it right. A lot of printer settings (properties) allow for scaling. You can also use a photo copies to scale. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |