Hobie Forums http://www.hobie.com/forums/ |
|
Rudder splay http://www.hobie.com/forums/viewtopic.php?f=15&t=3153 |
Page 1 of 1 |
Author: | Mark of Arabia [ Tue Mar 07, 2006 11:54 am ] |
Post subject: | Rudder splay |
I recently had to replace the entire port casting and rudder assembly on my H17 and was adjusting the rudders for toe-in etc. Whilst I was at it I checked that the rudders were hanging vertically and noticed that they are about 1 1/2 inches further apart at the bottom than the top. Is this designed that way, or are my gudgeons out of alignment? I also noticed that the rudder bolt holes on the new upper casting were not very well aligned and wondered if this could also have something to do with it? Although I can get the bolt through, it is putting an angular pressure on the rudder - which can't be good for it! Looks like some sloppy manufacturing, but I'm too far away to go complaining. Now the niggly detail. The new castings have a rather poor rough black finish, and the old ones a nice smooth grey. Anyone have any idea if this black is a protective coat which wears away to smooth grey, or do I have to sand them lightly and paint them? Thanks Mark |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |