Hobie Forums http://www.hobie.com/forums/ |
|
H17 crossbars meets hull http://www.hobie.com/forums/viewtopic.php?f=15&t=7718 |
Page 1 of 1 |
Author: | Wilmann [ Sun Aug 26, 2007 5:33 pm ] |
Post subject: | H17 crossbars meets hull |
Hi, I have a H17 from '99 but at the end of the crossbars where the hull castings meets the bars there are small cracks in the gelcoat on all 4 castings, my plans was to give it some silicone to close the cracks so the fiberglass wouln't get wet and the hulls maybe full of water. any insights? thanks for your answers |
Author: | mmiller [ Mon Aug 27, 2007 2:19 pm ] |
Post subject: | Cracks |
Cracks around the "hump" at the end of the crossbars? Cosmetic... I think this is somewhat cosmetic. Not a leak concern. |
Author: | Wilmann [ Tue Aug 28, 2007 3:31 am ] |
Post subject: | |
Great thanks, i will fill them up with silicone. and then out sailing |
Author: | h17cat [ Tue Aug 28, 2007 9:28 am ] |
Post subject: | |
Make sure the cross bar screws are tight. We tighten every day when sailing. A tee bar allen wrench is a very handy tool for this maintenance. Caleb Tarleton H-17 6446 |
Author: | mcnealmike [ Fri Sep 14, 2007 12:58 pm ] |
Post subject: | how about cracks on the outside of the hull |
how about cracks on the outside of the hull - as if the bar continued on through and made a U shaped crack |
Author: | mmiller [ Fri Sep 14, 2007 2:03 pm ] |
Post subject: | Re: how about cracks on the outside of the hull |
mcnealmike wrote: how about cracks on the outside of the hull - as if the bar continued on through and made a U shaped crack
That doesn't sound good. How about a photo? |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |