Hobie Forums http://www.hobie.com/forums/ |
|
Mast http://www.hobie.com/forums/viewtopic.php?f=17&t=3985 |
Page 1 of 1 |
Author: | H14Turbo [ Sun Jun 25, 2006 7:23 am ] |
Post subject: | Mast |
Guys How far up the mast is the place where all the stays go to. Thanks H14turbo |
Author: | mmiller [ Sun Jun 25, 2006 10:19 am ] |
Post subject: | High? |
About 3/4 up the mast... I don't have a spec at home, but can check back during the week if you need the exact dimension to the hole in the tang. The cut-off point for the CompTip installation is just above the tang and the instructions say 15' 1 1/8" from the bottom of the extrusion (not including base casting). |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |