Hobie Forums http://www.hobie.com/forums/ |
|
Bridle bolts pulled out http://www.hobie.com/forums/viewtopic.php?f=17&t=42946 |
Page 1 of 1 |
Author: | Cloggie [ Sat May 26, 2012 6:10 pm ] |
Post subject: | Bridle bolts pulled out |
Bought a used H14 recently from 92. While rigging today the bridle bolts complete came out of the hull. Thinking 1 side failed first, then the other, then the mast came down. My first assessment was the lack of a backing plate of any sort. But after cleaning up the holes and checking with a longer bolt it seems there is a backing plate. Can somebody confirm this? Longer bolts seem an easy fix. The Fiberglas was not really damaged, but the holes have opened up a bit to the point the bolts can wiggle a bit when not fully seated. Any suggestions for a good product to use to tighten up the holes a bit? I would like to re-create the original thread engagement. Thanks for any feedback |
Author: | mmiller [ Wed May 30, 2012 4:35 pm ] |
Post subject: | Re: Bridle bolts pulled out |
There is a 1/4" thick square aluminum plate molded-into the bow. You can use the next larger bolt, tap threads into it if not too badly corroded or worn. |
Author: | Cloggie [ Wed May 30, 2012 5:34 pm ] |
Post subject: | Re: Bridle bolts pulled out |
Thanks Matt, The plate is in good shape it seems. The previous owner put in bolts that were too short. I prototyped a fix for the slightly opened hole in the Fiberglas and will implement it this weekend. Should be out on the water shortly after that. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |