Hobie Cat Forums

It is currently Wed Aug 27, 2014 2:22 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Thu Sep 19, 2013 8:48 am 
Offline
Site Rank - Deck Hand

Joined: Tue Jun 11, 2013 11:24 pm
Posts: 9
Location: Las Vegas, Nevada
I bought my first Hobie Turbo 14 after sailing P16, Nacra 5.2 and a Hobie 20 for 7 years. Got it home, sanded and polished the hulls, had it sitting on 4 x 4 blocks of wood. I lifted the bow of the starboard hull until the port hull lifted, it was only 3'', but when I lifted the port hull, it was 6" before the starboard hull lifted. Same result from the stern by the way but reversed. Both the P16 and H20 had slight twist to them but they were equal, the Nacra was solid and had no twist. I've never seen a cat do like this before. I'm not worried about it, I'm sure it will sail just fine. Just wondering if anyone else has noticed this or have any suggestions.


Top
 Profile  
 
PostPosted: Thu Sep 19, 2013 11:18 am 
Offline
Site Rank - Old Salt

Joined: Mon May 09, 2005 10:25 am
Posts: 2553
Location: Jersey Shore
Probably some slight variation in the corner castings that allows the boat to twist unequally one side versus the other. Or perhaps a little uneven wear on one of the aluminum extrusions.

The H14 is a lot different than the other boats you mentioned. The frame includes pylons, crossbars, side bars, and corner castings, unlike boats like the H20 where you just have two crossbars held to the hulls with bolts which can be tightened. There's really no way to mechanically take slop out of the H14 frame. The first thing to try is to tighten the tramp as much as possible. If the boat's still too sloppy, then you can epoxy the frame together. That's really your only option.

sm


Top
 Profile  
 
PostPosted: Thu Sep 19, 2013 3:01 pm 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 8975
Location: Oceanside, California
The forward arched beams are VERY hard to bend perfectly and often ended up with a slight twist that could account for what you are seeing.

_________________
Matt Miller
Director of Parts and Accessory Sales
Hobie Cat USA


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group