| Hobie Forums http://www.hobie.com/forums/ |
|
| Fitting Dolphin striker assembly http://www.hobie.com/forums/viewtopic.php?f=17&t=52029 |
Page 1 of 1 |
| Author: | Pastymuncher [ Thu Jul 03, 2014 1:30 pm ] |
| Post subject: | Fitting Dolphin striker assembly |
Hi I have just purchased the aftermarket dolphin striker kit for my H14 from Murray's, but I am struggling to see exactly where to drill the holes in the castings?? I don't want to drill in the wrong place and ruin the cast(s). Any pictures or advice greatly appreciated 
|
|
| Author: | mmiller [ Thu Jul 03, 2014 2:41 pm ] |
| Post subject: | Re: Fitting Dolphin striker assembly |
Should be dimples? If not... at each "corner" maybe a half inch in. It's not at all critical. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|