Hobie Forums http://www.hobie.com/forums/ |
|
How to reeve Ronstan mainsheet blocks http://www.hobie.com/forums/viewtopic.php?f=20&t=25656 |
Page 1 of 1 |
Author: | Paris [ Sat May 29, 2010 6:32 pm ] |
Post subject: | How to reeve Ronstan mainsheet blocks |
Just bought a nice used H16. On the traveler there is a Ronstan RF51300 and on the boom there is a Ronstan RF51200. I don't see a becket anywhere. How should I reeve it? Drawings/illustrations appreciated. Paris. |
Author: | Paris [ Sun May 30, 2010 3:54 am ] |
Post subject: | Re: How to reeve Ronstan mainsheet blocks |
p.s. the lower block has three sheaves and the upper block has two. I don't see any becket. So how would I reeve this block set, in generic terms. And maybe I am missing a becket somewhere? on the boom on the traveler |
Author: | MBounds [ Sun May 30, 2010 6:45 am ] |
Post subject: | Re: How to reeve Ronstan mainsheet blocks |
The triple should go on the top (boom); the double on the traveller (assuming you also have a ratchet block/cleat on the bottom as well). Tie the bitter end of the mainsheet to the extra boom bail. |
Author: | Paris [ Sun May 30, 2010 1:12 pm ] |
Post subject: | Re: How to reeve Ronstan mainsheet blocks |
MBounds wrote: The triple should go on the top (boom); the double on the traveller (assuming you also have a ratchet block/cleat on the bottom as well). Tie the bitter end of the mainsheet to the extra boom bail. And then what does the rest of the reeving look like? |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |