Hobie Cat Forums

It is currently Tue Sep 23, 2014 8:27 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sun Aug 29, 2010 1:59 pm 
Offline
Site Rank - Deck Hand

Joined: Fri Jul 31, 2009 7:17 pm
Posts: 1
Just wondering what would be the best way to make the molded-in rod holder on my 2010 outback larger so the rod holder extension tube will fit completely flush. It won't go completely down as the tube diameter is too small. It could go another 2" or so down. I tested multiple rod holder extensions and it is definitely the tube diameter on the kayak.

Any suggestions? Is it safe to sand down the inside of the rod holder? Or, should I sand down the extension tube and use only that one in that molded-in hole?

Thanks in advance.


Top
 Profile  
 
PostPosted: Sun Aug 29, 2010 4:37 pm 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 9032
Location: Oceanside, California
Sand the extension... not the hull. A looser fit in the other holes is not a problem.

_________________
Matt Miller
Director of Parts and Accessory Sales
Hobie Cat USA


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group