Hobie Forums :: View topic - Failed A-Frame on Bravo

Hobie Forums http://www.hobie.com/forums/

Failed A-Frame on Bravo http://www.hobie.com/forums/viewtopic.php?f=20&t=37053	Page 1 of 1

Author:	drej [ Tue Jul 26, 2011 1:16 pm ]
Post subject:	Failed A-Frame on Bravo
Hey Everyone, Was sailing my Bravo in about 12 mph winds when the front post on the A-frame supporting the mast failed at the lower rivets. Fortunately, was up wind from the house and able to sail the boat in, while the mast was canted at about a 45 degree angle. Upon inspection, it appears, corrosion on the bar that holds the A-frame forward post appears to be the culprit. Looks like galvanic corrosion where the rivets held the post to the lower rod weakened the rod and it snapped off. I know I have seen a post on how to repair this, but can't find it. Anyone have any thoughts? View of the carnage attached.

Author:	Jbernier [ Tue Jul 26, 2011 2:33 pm ]
Post subject:	Re: Failed A-Frame on Bravo
Should be able to remove that part by unscrewing it from the molded insert - and replace it with a new piece (looks like it just snapped at the base from age and fatigue...not likely from just that one use in 12 mph winds - that happened over time) - Hopefully you can tweak the frame back into shape - but that might need replacing too. - just order the parts from any Hobie dealer, the illustrated parts guide is located here: http://2010.archive.hobiecat.com/suppor ... _Bravo.pdf For a dealer call toll free 1800hobie49 to order

Author:	drej [ Tue Jul 26, 2011 5:28 pm ]
Post subject:	Re: Failed A-Frame on Bravo
Thanks for the help. I will try to remove it tomorrow. I agree that age and stress was the most likely culprit...not the wind in this case. Although, its mostly age/exposure as the boat hasn't had that much use As for the A-frame...I will do my best to straighten it. Will probably have to remove it from boat so as not to damage connections. I have a dealer I can use for parts. Thanks!

Page 1 of 1	All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/