Hobie Forums http://www.hobie.com/forums/ |
|
remove the frame from the hulls http://www.hobie.com/forums/viewtopic.php?f=20&t=38025 |
Page 1 of 1 |
Author: | goatwings [ Fri Aug 26, 2011 12:53 pm ] |
Post subject: | remove the frame from the hulls |
I have a 14 hobie cat and I want to take the trampolene frame off of the hulls. I removed the bolts and two of them came right out but the other two are frozen in the holders with time and corrison. I put wd40 and oil around them but they want move at all. Does anyone have any suggistions on what to use? |
Author: | Bacho [ Sun Aug 28, 2011 1:16 pm ] |
Post subject: | Re: remove the frame from the hulls |
You need penetrating oil ssuch as pb blaster. Spray it on and let it soak and respray over a few days. |
Author: | kentnothstine [ Fri Sep 09, 2011 1:51 pm ] |
Post subject: | Re: remove the frame from the hulls |
Bacho wrote: You need penetrating oil ssuch as pb blaster. Spray it on and let it soak and respray over a few days. +1 Take your time, and maybe tap bolt head lightly with a hammer while twisting if you can. |
Author: | 56kz2slow [ Fri Sep 09, 2011 2:41 pm ] |
Post subject: | Re: remove the frame from the hulls |
Is it the 2 bolts you cannot remove or the corner casting from the pylon? If the latter, I had to use a rubber mallet and hit on the corner casting upwards to remove it. It would only budge a hair at a time, but it would move. It's an awkward angle to hit, so you can hit to hard either. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |