Hobie Forums
http://www.hobie.com/forums/

Hobie 16 hull cut away view or diagram??
http://www.hobie.com/forums/viewtopic.php?f=20&t=4301
Page 1 of 1

Author:  ALEXSAILS [ Sun Jul 23, 2006 8:31 pm ]
Post subject:  Hobie 16 hull cut away view or diagram??

Hi, Anyone has a lenght wise cut away view or diagram of a H16 hull??

I need to know how deep into the hull are the pylons installed at factory and what is supporting them at the keel inside the hull.

One of my decks depressed/flexed down around the base of the pylon! Before I cut and access hole on the side of the hull I need to know this.

thanks!

Author:  MBounds [ Mon Jul 24, 2006 7:12 am ]
Post subject: 

These are on the site http://www.thebeachcats.com under "Pictures", "Technical", "Inside the Hobie 16"

Image

Author:  arcsurf [ Fri Sep 16, 2011 7:53 pm ]
Post subject:  Re: Hobie 16 hull cut away view or diagram??

This compression point seems to be the source of continuous hull cracking.
How about an injection of a high density closed cell foam around this point to distribute the loads more evenly?
Access is the problem too.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/