Hobie Cat Forums

It is currently Fri Dec 26, 2014 11:12 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Thu Oct 30, 2003 10:31 pm 
Offline
Site Rank - Deck Hand

Joined: Sat Aug 30, 2003 7:28 pm
Posts: 3
Location: FWB, FL
I have a hole in my O'Day Dailsailer mast where the spreader bracket connects (I know this is the Hobie forum, but I also own a Hobie 14 so I feel justified in asking my question :) ). The hole is right where one of the rivets to connect the bracket that supports the spreader should be. My plan to fix it is to rivet a large aluminim plate that matches the curvature of the mast over the damaged area then reduce the length of the spreader itself by the width of the plate so the run of the rigging isn't affected. Would this would be adequate / structurally sound?

Thanks,
Bill


Top
 Profile  
 
 Post subject:
PostPosted: Tue Nov 04, 2003 3:38 pm 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 9328
Location: Oceanside, California
Sounds ok.

_________________
Matt Miller
Director of Parts and Accessory Sales
Hobie Cat USA


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group