Hobie Forums http://www.hobie.com/forums/ |
|
Size of rivets of corner casting of the crossbar of a HC16. http://www.hobie.com/forums/viewtopic.php?f=20&t=910 |
Page 1 of 1 |
Author: | Rony [ Tue Jun 29, 2004 3:35 am ] |
Post subject: | Size of rivets of corner casting of the crossbar of a HC16. |
In writing from Spain. So, forgive my english, please. I want to replace rivets of corner casting of the crossbar of my HC16. Does anyone know which is the size of them? Thanks and thanks Rony. |
Author: | MBounds [ Tue Jun 29, 2004 5:19 am ] |
Post subject: | |
In the US, they are 3/16 inch stainless steel. 3/16 in. = 4.7625 mm I don't know what the available metric sizes of rivets are, but that is a starting point for you. |
Author: | Rony [ Tue Jun 29, 2004 5:41 am ] |
Post subject: | |
Wow, thanks a lot to U. I'll try with them today. RONY |
Author: | Rony [ Mon Jul 05, 2004 12:57 am ] |
Post subject: | |
Rivets are OK. I've had to use two sizes: 4.5mm and 5mm because some holes are greater than others. But, finally, it's everythng OK. Tomorrow, Tuesday, I'll launch my brilliant and marvelous CURRITO. Everybody stand aside!! RONY |
Author: | Rony [ Thu Jul 08, 2004 4:32 am ] |
Post subject: | |
Launching was a total success. No wind but it was really exciting. We sailed during an hour testing if is was everything OK. One more Hobie cutting waters!! RONY (Spain) |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |