Hobie Forums
http://www.hobie.com/forums/

Motor Mount -Crossbar integrity
http://www.hobie.com/forums/viewtopic.php?f=23&t=19779		 Page 1 of 1
Author:  bjkIII [ Mon Jan 18, 2010 12:59 pm ]
Post subject:  Motor Mount -Crossbar integrity
I am thinking of mounting a motor. Do the mounts where they drill into the crossbar weaken the structural integrity of the crossbar? Has anyone considered a mount that is clamped on in some way without drilling into the crossbar?
Author:  XxTrasHxX [ Tue Jan 19, 2010 5:21 pm ]
Post subject:  Re: Motor Mount -Crossbar integrity
I have been looking into motor mounts for the getaway for a while now and have never herd of any damage from the cheata mounts bolts going through the cross bar. I will be fabbing a new mount for my self in the next couple of months that will clamp onto the rear crossbar and will be easily removed when its not being used I will post full build details when I'm done.
Author:  the ferret [ Sat Jan 23, 2010 1:58 am ]
Post subject:  Re: Motor Mount -Crossbar integrity
bjkIII wrote:
I am thinking of mounting a motor. Do the mounts where they drill into the crossbar weaken the structural integrity of the crossbar? Has anyone considered a mount that is clamped on in some way without drilling into the crossbar?

Iv'e drilled and bolted mine, it's a lot firmer than the clamp system I had before. I can just pull one pin and the arm comes off leaving the mounting in place. You have to take care there are no sharp bits to cause injury, Iv'e used "cup head " bolts down from the top and welded them in, nice and smooth. :wink:

Image
Image
Image
Image
Author:  XxTrasHxX [ Mon Jan 25, 2010 6:34 pm ]
Post subject:  Re: Motor Mount -Crossbar integrity
Great pics of your home made mount do you mind if I re-post them in my post (Cheata Motor Mount or Home Made)?
Author:  the ferret [ Tue Jan 26, 2010 1:20 am ]
Post subject:  Re: Motor Mount -Crossbar integrity
Yeah, Go for it Mate. :D
Author:  demus [ Sun Feb 28, 2010 12:19 pm ]
Post subject:  Re: Motor Mount -Crossbar integrity
I'd be willing to buy one from you If you make it :), just send the instructions on how to assemble it.
Author:  the ferret [ Mon Mar 01, 2010 8:09 pm ]
Post subject:  Re: Motor Mount -Crossbar integrity
Yep no problem, it is already assembled, you only need a clamp, a power drill and a spanner,takes about 20 minutes, email sent.
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/