Hobie Forums http://www.hobie.com/forums/ |
|
Main Halyard Replacement http://www.hobie.com/forums/viewtopic.php?f=23&t=25697 |
Page 1 of 1 |
Author: | seaflyer [ Sun May 30, 2010 2:44 pm ] |
Post subject: | Main Halyard Replacement |
Well, the 2010 shakedown cruise is complete. The day got started late due to a lack of wind but we finally made it out. After a jibe to head back to shore for some lunch I heard a pop and looked around to see what the situation was. Well, a quick survey revealed that the mainsail was sagging from the top of the mast and I could see the wire from the halyard waving to me. It appears that the union of the wire and the nylon rusted apart resulting in a catastrophic failure. So, I come to you my fellow cat sailors for some help. I have not seen a Getaway specifc halyard but did notice that there is an H16 kit for comptip masts, is that what I need ? Secondly once I get the right kit, it is really as simple as just feedking the line through roller at the top of the mast. As a note, I have an 03 boat that has always been stored outside and this is the original rigging. I look forward to everyone'e input and hope to be back on the water soon! |
Author: | KeithB [ Tue Jun 01, 2010 2:09 pm ] |
Post subject: | Re: Main Halyard Replacement |
I don't understand, can't you just get a getaway halyard from a hobie dealer in your area. Oh yeah, just feed it through the pulley at the top of the mast. Just make sure to thread it over the right direction. I messed it up once and had to lower the mast again to correct it. |
Author: | Roy [ Tue Jun 01, 2010 7:04 pm ] |
Post subject: | Re: Main Halyard Replacement |
After 3 yrs of sitting outside I think you better have a very close look at all the standing rigging. Replacement of all the standing rigging is far less costly than a bent mast or worse a structural failure of a hull caused by the falling mast. |
Author: | mmiller [ Wed Jun 02, 2010 10:46 am ] |
Post subject: | Re: Main Halyard Replacement |
Getaway halyard is # 37651001 http://www.hobiecat.com/company/dealer.html |
Author: | seaflyer [ Wed Jun 02, 2010 5:55 pm ] |
Post subject: | Re: Main Halyard Replacement |
Thanks guys. The halyard is on order. By the way, I put new shrouds on her fall '09, so we should be good to go. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |