Hobie Cat Forums

It is currently Sat Aug 30, 2014 6:09 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Wed Nov 21, 2012 9:11 am 
Offline
Site Rank - Captain

Joined: Mon Dec 22, 2008 7:02 pm
Posts: 129
Location: Rockford, IL
So now instead of leaving my Getaway set up in the marina, I'm trailer sailing it. Hooking up the front bridle is a pain in the neck! Specifically, trying to get the 2 tiny little ring-dings in the clevis pins. I have big hands, and those are tiny rings!

I've thought of using the ball lock pins (aka quick pins) instead, but for 2 possible problems. I'm afraid of them getting pulled out by the spinnaker if it should hook them, and I'm afraid that since they are hollow, they aren't strong enough and might break.

Has anyone had any experience with the ball lock pins, or have another solution for the front bridle clevis ring-dings?

_________________
Yet another Bob!


Top
 Profile  
 
PostPosted: Wed Nov 21, 2012 10:30 am 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 8978
Location: Oceanside, California
My concerns are ... Ball lock pins (with the thumb button release) are hollow and not as strong as a solid pin. The ball on the ball locks sometimes stick or even fall out.

I always say "quick release" is not something I want to hold my mast up. These are better for mainsheet systems, tillers etc.

Maybe do some practice with the rings. They aren't too tough to use if you know how. You can even get a tool for them.

mmiller wrote:
Here are a couple of thoughts on the ring and pins. They are definitely more secure, so if you can learn to work with them they would be better. They don't require special tools either. The small rings are stiff, so perhaps just a small blade driver or fingernail file to open may make them easier.

Pry open with your thumbnail. Place the nail in the ring within 1/8-1/4 inch of the end to pry open. push your thumb and forefinger in opposite directions to pry open. Slip onto the clevis pin and spin on.

Image

Pry open with the clevis pin. Use the pin to wedge the ring open.

Image

Pry open with a small tool.

Image

There is a tool that holds them open for installation. I think fishing shops may have the tool. Someone told me they use them on fishing gear.

_________________
Matt Miller
Director of Parts and Accessory Sales
Hobie Cat USA


Top
 Profile  
 
PostPosted: Sat Jun 08, 2013 10:12 pm 
Offline
Site Rank - Deck Hand

Joined: Mon Nov 26, 2007 1:43 pm
Posts: 22
I also considered, and ruled out ball lock pins. Instead I got some bigger rings from my Hobie dealer. Much easier to put on than the ones that came with the boat.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group