Hobie Forums
http://www.hobie.com/forums/

battened jib - jib dimension
http://www.hobie.com/forums/viewtopic.php?f=23&t=46167
Page 1 of 1

Author:  SeaLord [ Mon Jan 07, 2013 10:16 am ]
Post subject:  battened jib - jib dimension

Hi
I have just bought a 2005 and it has a battened jib. I guess that this came from another model. I would like to replace it and I have 2 options:
1 get another battened but i have no clue on which from the other hobie model may fit. does anyone have a clue ?
2 re-install the original but I do not know if the current set up would allow a furling jib. what should i check to see compatibility ?

Thank you

Author:  kevinbatchelor [ Fri Mar 01, 2013 7:19 pm ]
Post subject:  Re: battened jib - jib dimension

I think the jib bridle lengths are 2'X2" according to the instructions, if this is the same then you need a few other pieces too, the fore stay assembly and the sail.

http://static.hobiecat.com/digital_assets/PARTS_Getaway.pdf

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/