I am a new Wave owner, and also brand new to this forum. I'm seeking advice about how to solve what I suspect is a problem for every other Wave owner with back rests installed. The sleeves covering the padding on the back rests slide off the back and over the rear curve in the tubing, and I'm getting tired of readjusting them all the time.
I've thought about small bungees at each end of the sleeves, but I doubt they would prevent the slide... maybe only reduce the sliding.
I've also considered cutting the foam padding to be shorter than the sleeve material, then hemming in a tunnel with a cord in it at each end, which could be pulled tight over each end of the padding to keep the sleeve from moving. That's a lot of work though, and I'm not up to doing the sowing myself.
What are your thoughts and suggestions?