Hobie Cat Forums

It is currently Sat Oct 25, 2014 12:22 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Wed Sep 06, 2006 10:59 am 
Offline
Site Rank - Deck Hand

Joined: Tue Sep 05, 2006 7:25 pm
Posts: 4
Location: East Lansing,MI
I bought a used Wave this last spring and orderred a jib kit. My Wave has apparently spent some time in salt water and many of the fittings on the boat have corroded threads. To install the jib kit, you must remove and reinstall the bow bridle fittings (4 screws) . After 3 weeks trying penetrating oil etc, I successfully removed the two screws holding the starboard fitting, however, both port fitting screw heads broke off. This left me with two inserts on the bow of the port hull with screw bodies seized into the inserts' threads.

What's the recommended practice to remove these two "headless" screws from the inserts? It sounds like the inserts are brass and the screws appear to be stainless steel. Does anyone have experience with this problem?

Also, I have a standard Wave with the exterior plugs on the outside of the hull opposite the jam cleat installation point so I need to put in hull access hatches. I'm planning on 5" hatches out of the calendar. Is this a better plan than removing the forward seating pad and going through the sealed plate that is apparently there?


Top
 Profile  
 
 Post subject:
PostPosted: Thu Sep 07, 2006 2:59 pm 
Offline
Authorized Hobie Dealer

Joined: Mon Jun 02, 2003 7:35 pm
Posts: 1370
Location: 315 N. Hwy 79 Panama City Beach, FL 32413 850-235-2281
I would go thru the seat pad port, it prob. isn't sealed good anymore unless it has been resealed.

You are going to have to get a reverse drill bit and get the broken screw out, All I can say is good luck. With my rental boat I always had this problem, we started taking the screws out about once a Month to make sure they did not freeze up, they only get fresh water when it rained.

_________________
Brad Stephens
Brad@sunjammers.com
(866) 786-5266 <--- Advice HOTline
http://www.sunjammers.com
www.facebook.com/sunjammers
Image


Top
 Profile  
 
 Post subject:
PostPosted: Sat Sep 09, 2006 10:51 am 
Offline
Site Rank - Old Salt

Joined: Fri Jul 07, 2006 9:40 am
Posts: 952
Location: Dallas, TX
There's some stuff we use sometimes called CorrosionX. It doesn't always work. But it often works when nothing else has. I keep a can on the bench here and at home.

http://corrosionxproducts.com/index.htm

Brian C


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group