Hobie Forums http://www.hobie.com/forums/ |
|
Furling Kit for Revo http://www.hobie.com/forums/viewtopic.php?f=32&t=42626 |
Page 1 of 1 |
Author: | Yak Bug [ Thu May 10, 2012 8:53 pm ] |
Post subject: | Furling Kit for Revo |
I want to build or buy a furling device for mast on my Revo. Any suggestions? I have the standard sail kit and furling by hand is a drag! Please advise. Thanks.... |
Author: | Jbernier [ Fri May 11, 2012 8:09 am ] |
Post subject: | Re: Furling Kit for Revo |
I did a search and found this older thread where another user built one himself. viewtopic.php?f=32&t=7740 |
Author: | dregsfan [ Fri May 11, 2012 3:22 pm ] |
Post subject: | Re: Furling Kit for Revo |
Can't buy one, ya gotta make one. Mine is similar to the one shown in Jbernier's link. Pretty easy to make if you know which end of the screwdriver to hold. |
Author: | stringy [ Fri May 11, 2012 4:13 pm ] |
Post subject: | Re: Furling Kit for Revo |
Jbernier wrote: I did a search and found this older thread where another user built one himself. viewtopic.php?f=32&t=7740 That was a very early mod which is simplified here: viewtopic.php?f=32&t=8455 Revo_1756 simplified it even more here: viewtopic.php?f=32&t=34749 You may also want to check out Halibu's mod mentioned in the thread. It seems popular with many users, but I haven't tried it. |
Author: | Yak Bug [ Mon May 21, 2012 7:12 am ] |
Post subject: | Re: Furling Kit for Revo |
Thank you! |
Author: | VaBeach1 [ Mon Jun 11, 2012 5:56 am ] |
Post subject: | Re: Furling Kit for Revo |
On my 2011 Outback, I was able to utilize the exsisting bolt holes on both front sides of the Yak. (The rudder up and down lines) 1. Purchased the Hobie Anchor kit and utilized the included Harken Blocks. a. Had to make the bolt holes in the Harken block a tad bit larger to fit the exsisting bolt size. b. Purchased a 1.5" bolt/same width as the existing ones. c. Make sure you only undo one bolt at a time! Wala- works flawlessly! |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |