Hobie Forums http://www.hobie.com/forums/ |
|
Suggestions for float arm length http://www.hobie.com/forums/viewtopic.php?f=32&t=45712 |
Page 1 of 1 |
Author: | CaptPJB [ Sat Nov 17, 2012 2:56 pm ] |
Post subject: | Suggestions for float arm length |
Reading the posts it seems that people have used 30" and the longer 40 or 45 inch arms. Was thinking the 45's might be better as mentioned in a post above pretty much the ratio of the Adventure Island. Any advice or comments appreciated |
Author: | AllElectricPA14 [ Sat Apr 06, 2013 2:16 pm ] |
Post subject: | Re: Suggestions for float arm length |
Because I made my own I made them adjustable in two in increments. So from flush with the side of the PA14 to having the outside of the float at 5 feet from the center of the boat for extreme stability. |
Author: | CaptPJB [ Sat Apr 06, 2013 4:36 pm ] |
Post subject: | Re: Suggestions for float arm length |
AllElectricPA14 wrote: Because I made my own I made them adjustable in two in increments. So from flush with the side of the PA14 to having the outside of the float at 5 feet from the center of the boat for extreme stability. Thanks for the input I am assuming that at five foot it does not over stress the bar to hull connection? I was thinking wider was better all things being equal I like your concept of adjustable arms Peter |
Author: | FishIt [ Fri Jul 19, 2013 11:38 am ] |
Post subject: | Re: Suggestions for float arm length |
Hey, AllElectricPA14: How did you mount the trolling motor shaft in the Mirage drive well plug? Neat boat! |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |