Hobie Cat Forums

It is currently Fri Nov 28, 2014 1:49 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: Sidekicks/Revo
PostPosted: Thu Jul 05, 2007 1:48 pm 
Offline
Site Rank - Deck Hand

Joined: Mon Feb 12, 2007 12:14 pm
Posts: 18
Location: Va Beach/Hatteras
So I got the sail a few days ago and am getting it down pretty good. What a blast, takes me back to days of dingy sailing. Well as you all know, you can't have the sail w/out the floaties! I hear that they are secured w/wellnuts. I tried those things w/ rodholders and they wanted to pop out so I replaced them /nuts and bolts. Did I do something wrong with the wellnut? Can't you secure with screws or is placement a prob?


Top
 Profile  
 
 Post subject:
PostPosted: Fri Jul 06, 2007 6:24 am 
Offline
Site Rank - Old Salt

Joined: Thu Jul 27, 2006 4:50 pm
Posts: 461
Location: sacramento california
Hi Ya Bully :wink:
You can always sail without the floaties but having the sidekicks reduces the possibility of going upside down when sailing in gusty winds and waves. Like anything else there is still no substitute for using good judgment , common sense and caution (not that I have much :oops: ) when conditions become rougher.

I used the well nut anchors that came with the sidekick kit because they can be an easy simple way to do a blind side attachment in thin materials just be sure to crank them down good and tight .
However I wanted to remove them once to add a riser/spacer under the mount clamps and found out the hard way that they could not be reused once they had been tightened up.

I then completed my remount with stainless screws , lock nuts, rubber sealing washers on both sides of the hull to prevent water leaks and large fender washers to spread the load, while reaching back under the opened hatch and through bolting the clamp brackets to the hull. I am certain they are now securely mounted to the deck and can feel confident that they will hold under any conditions while out on the water
....Have fun out there
.........kepnutz


Top
 Profile  
 
 Post subject:
PostPosted: Sun Jul 08, 2007 7:13 pm 
Offline
Site Rank - Captain

Joined: Thu May 17, 2007 4:43 am
Posts: 130
Location: Seal Beach California
After I had a set of well nuts rip out I drilled and tapped a piece of aluminum and bolted the side kick mounts to them. I made the pieces about a foot long to make them easier to hold in place while I screwed in the bolts. The difference in diameter between the original well nut mounting holes and the #10 bolts was taken up by using nylon washers, 3M 5200 was used to seal the assembly.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group