Hobie Forums http://www.hobie.com/forums/ |
|
Rudder setup http://www.hobie.com/forums/viewtopic.php?f=34&t=23569 |
Page 1 of 1 |
Author: | pierman926 [ Mon Apr 19, 2010 3:08 pm ] |
Post subject: | Rudder setup |
How do I determine where to drill the holes for the castings in my new EPO2 rudders? |
Author: | mmiller [ Mon Apr 19, 2010 3:43 pm ] |
Post subject: | Re: Rudder setup |
http://www.hobiecat.com/support/tech/rudder.html |
Author: | pierman926 [ Mon Apr 19, 2010 6:50 pm ] |
Post subject: | Re: Rudder setup |
It's a Hobie 20 I'm putting the new rudders on. Should I be concerned that the holes in the template don't match the holes in the old rudders? |
Author: | mmiller [ Mon Apr 19, 2010 9:14 pm ] |
Post subject: | Re: Rudder setup |
The original H20 blade does not fit this template. The locations marked "20" are the new locations for the H20 using the EPO2 blade. |
Author: | pierman926 [ Tue Apr 20, 2010 5:48 am ] |
Post subject: | Re: Rudder setup |
Thanks |
Author: | MVD [ Tue Apr 20, 2010 7:28 pm ] |
Post subject: | Re: Rudder setup |
If you have confidence in your Hobie dealer and if they have a drill press, you could ask them to drill the holes for you. If you forked over a bunch of dough for a new set of rudders, they probably wouldn't hesitate. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |