Hobie Forums
http://www.hobie.com/forums/

Jib traveler car set-up - PVC pipe?
http://www.hobie.com/forums/viewtopic.php?f=34&t=35708
Page 1 of 1

Author:  NAHCA555 [ Sun May 22, 2011 1:21 am ]
Post subject:  Jib traveler car set-up - PVC pipe?

I think when I last sailed a H-20 we used a PVC pipe to cover the jib car cable that goes across the tramp... and the return bungie was inside too.

On the new tramp (thanks Jeremy!) there is a cover or "tunnel" all that goes through now.... do you all still use a PVC pipe or forget it and go without?

Looking forward to getting this baby on the water :D

Author:  MVD [ Mon May 23, 2011 7:03 pm ]
Post subject:  Re: Jib traveler car set-up - PVC pipe?

I've been sailing and racing the 20 for three years now. During my brief tenure I've never seen anyone run their jib traveler cable (or Dyneema line as is now the most common material) through a PVC pipe. I'm one of the few that still uses a cable. Like you, I have a new trampoline so my cable runs through the pouch in the center of it.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/