Hobie Forums
http://www.hobie.com/forums/

Fitting snuffer to H20 spin pole
http://www.hobie.com/forums/viewtopic.php?f=34&t=6027
Page 1 of 1

Author:  pasdnous [ Wed Jan 31, 2007 11:54 am ]
Post subject:  Fitting snuffer to H20 spin pole

Hello!!!!! We found a used Hobie Trumpet cheap. I think this is the one that used to come with the Tigers. Anyway, does anyone have any ideas for fitting this to our factory H20 spin pole? It seems the Tiger pole is only 1.5" in diameter, the H20 pole is 2 inches, so the clips that are mounted on the trumpet are too small. The first thing that comes to mind is duct tape, but I'm not sure how this would hold up in the water. haahah I guess we could carry a roll on board.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/