Hobie Cat Forums

It is currently Sat Aug 30, 2014 12:19 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Fri Jun 01, 2007 11:16 am 
Offline
Site Rank - Captain

Joined: Thu Mar 24, 2005 11:20 am
Posts: 53
Location: usa
I am ready to rivet all my 20 parts on my new extrusion.
And my old mast is bent like a wet noodle. I am looking for the drill distances up the mast. especially the diamond wire points and upper diamond wire mounts. Also the cut length for a hobie 20 mast prior to comptip installation.
The donor mast is a h18 all alluminum extrusion.

Can anyone email me working drawings. or specs?
thanks
ben
Nak7ben@aol.com


Top
 Profile  
 
 Post subject: Drawings
PostPosted: Fri Jun 08, 2007 9:41 am 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 8978
Location: Oceanside, California
Unfortunately drawings are not available for distribution from Hobie Cat. You would have to take the measurements off your old mast.

_________________
Matt Miller
Director of Parts and Accessory Sales
Hobie Cat USA


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group