Hobie Cat Forums

It is currently Wed Dec 24, 2014 5:17 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: spinnaker protection
PostPosted: Sat Jul 12, 2008 7:16 pm 
Offline
Site Rank - Captain

Joined: Mon Jun 26, 2006 6:49 am
Posts: 82
I am an H20 sailer but i thought I would post this here since everyone in this forum should have spinnaker experience....

On our boat we are using a tiger pole with a mid-pole snuffer. It has the short (~6 inch) figerglass tube at the end then the cloth bag which extends back to the crossbar. Anyway I have noticed that I am getting small pinhole sized tears in my sail and I think it has to do with the dousing, and particularily rubbing of the sail at the point where the bridle wire meets the forestay. I want to put a boot of some sort around this to protect the sail. I saw such a thing on an I17 once, i think. Anyone had similar problems? Any clever fixes? thanks. seth


Top
 Profile  
 
 Post subject:
PostPosted: Sun Jul 13, 2008 12:21 pm 
Offline
Site Rank - Old Salt

Joined: Fri Aug 03, 2007 10:46 am
Posts: 1089
Location: eureka,california
one where is your snuffer located in relation to the bridle. I run mine out about a foot forward from the bridle. Second coat the spin and snuffer with holimkol seal and glide or mc lubes sail kote. Third the snu by barefoot studios is a better snuffer for saving the spin easier in and out. Last you can strip the coating off the snuffer line, and just run the core. Keep the snuffer line lubed, and clean.

_________________
Rich Vilvens
F-18 5150
R.Vilvens@yahoo.com
http://www.sailblogs.com/member/f-185150sailing/


Top
 Profile  
 
 Post subject:
PostPosted: Sun Jul 13, 2008 6:16 pm 
Offline
Hobie Approved Guru

Joined: Mon Jul 14, 2003 7:11 pm
Posts: 4641
Location: Detroit, MI
Pin holes are usually caused by the snuffer line rubbing against the cloth when it's bunched up against the snuffer ring. Actually melts a hole through the cloth.

Rich has the program down. Lube everything. Tape all sharp edges & rings.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group