Hobie Forums http://www.hobie.com/forums/ |
|
Wildcat dagger uphaul http://www.hobie.com/forums/viewtopic.php?f=37&t=43922 |
Page 1 of 1 |
Author: | Capt. Ahab [ Mon Jul 16, 2012 6:04 pm ] |
Post subject: | Wildcat dagger uphaul |
What is the correct size line for the up haul and what size hole must be drilled. Ahab |
Author: | Capt. Ahab [ Wed Jul 18, 2012 7:19 am ] |
Post subject: | Re: Wildcat dagger uphaul |
Got the hole drilled (5/32) but looks like I need a counter bore or recess to fit the square knot? worked great last night on the shake down, two races last night and took a 4th and a 1st but pulled too hard on the last down wind leg and the half hitch pulled apart letting the board come almost all the way up! Any advice? Ahab |
Author: | Jbernier [ Wed Jul 18, 2012 8:34 am ] |
Post subject: | Re: Wildcat dagger uphaul |
The other JB told me... "use 5/32" amsteel line and drill a hole slightly bigger than 5/32". Tie off with a figure 8 knot. Works for me. Noticed you haven't registered for the Worlds yet...pre-reg deadline is August 1. It'll cost $150 more after that." |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |