Hobie Forums http://www.hobie.com/forums/ |
|
Bravo hull cracks http://www.hobie.com/forums/viewtopic.php?f=42&t=13554 |
Page 1 of 1 |
Author: | elklo [ Fri Aug 07, 2009 11:15 am ] |
Post subject: | Bravo hull cracks |
The 2004 Bravo I'm considering buying has a few fine cracks in the hull at the point of attachment of the tiller. Any and all input about this situation will be appreciated. Should this condition be a deal killer? |
Author: | RobDek [ Fri Aug 07, 2009 12:48 pm ] |
Post subject: | Re: Bravo hull cracks |
Are these surface cracks or scratches? If the hull is cracked right through...run away. Repairing polyethylene is very difficult at best. |
Author: | mmiller [ Fri Aug 07, 2009 12:52 pm ] |
Post subject: | Re: Bravo hull cracks |
Photos? I think small / short cracks emanating from the molded-in hardware are not usually a big issue. May just be thin right at the point the material intersects with the embedded hardware. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |