Hobie Forums http://www.hobie.com/forums/ |
|
Bravo Mast Base Plate Screw sticking out http://www.hobie.com/forums/viewtopic.php?f=42&t=31079 |
Page 1 of 1 |
Author: | RobDek [ Sun Sep 05, 2010 4:20 pm ] |
Post subject: | Bravo Mast Base Plate Screw sticking out |
Today, I purchased an almost new Hobie Bravo. One of the screws on the mast base plate is sticking out. I removed the screw and cleaned out the hole but the screw still bottoms out prematurely. Do I simply add a washer or two to make up the difference or go through the trouble of delicately drilling a deeper hole to accommodate the screw? Or can I purchase a shorter screw? |
Author: | jp [ Tue Sep 07, 2010 1:28 am ] |
Post subject: | Re: Bravo Mast Base Plate Screw sticking out |
Hey, good shot Rob. I never thought of posting that question on this forum. I would bet that the screw, as is, will not pose any problems. But, it will be better repaired. Hopefully someone will have the answer. |
Author: | RobDek [ Tue Sep 07, 2010 4:28 am ] |
Post subject: | Re: Bravo Mast Base Plate Screw sticking out |
I removed all the screws and it seems that the brass insert was not fully threaded, so I made up the gap by using a couple of lock washers. One day I may use a tap to complete the job. viewtopic.php?f=20&p=122931#p122931 |
Author: | ctricoche [ Fri Sep 24, 2010 4:03 pm ] |
Post subject: | Re: Bravo Mast Base Plate Screw sticking out |
I don't see why the washer wont work. I thing you will be fine . |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |