Will the Bravo fit between the wheel wells of a pickup truck?
Do you put carpet or foam down to cushion the hull?
| Hobie Forums http://www.hobie.com/forums/ |
|
| In a pickup bed http://www.hobie.com/forums/viewtopic.php?f=42&t=8908 |
Page 1 of 1 |
| Author: | chas5131 [ Sat Mar 15, 2008 11:53 am ] |
| Post subject: | In a pickup bed |
Will the Bravo fit between the wheel wells of a pickup truck? Do you put carpet or foam down to cushion the hull?
|
|
| Author: | The Dog [ Sun Mar 16, 2008 7:37 am ] |
| Post subject: | |
Sure... In a long bed, fleet-side, full size truck. Won't fit in toy trucks or step-sides. You can make it work in a short bed, but it's kind of ugly. As for padding, I just have a rubber matt in the bed. I usually put a couple of foam blocks at the bow. The Bravo does ride better bow forward. Helps to have tie down points low in the truck bed. Brian C |
|
| Author: | sunjammers [ Sun Mar 16, 2008 2:27 pm ] |
| Post subject: | |
I have a short bed tundra and I put Bravo's in there all the time, I put the stern in 1st so i can leave the a frame, I have kayak racks the sometime interfere with the a frame. I have a spay in bed liner so I do not put any extra padding in there. Just be careful that the gudgeon's do not get messed up if you go stern 1st! |
|
| Author: | chas5131 [ Mon Apr 28, 2008 8:03 am ] |
| Post subject: | Mast? |
What do you do with the mast? |
|
| Author: | The Dog [ Mon Apr 28, 2008 4:01 pm ] |
| Post subject: | |
Broke it down into two pieces then tied it to the boat. Sail, battens and "Stuff" went into the cab. Brian C |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|